How Can I Customise My Boot Buddy?

More than likely, we have the standard dimensions on file to make Boot Buddy products fit your car perfectly. If, however, the standard dimensions don't quite fit your specific needs, we're happy to customise them at no extra charge.

Shown below are the customisation options you can choose and the measurements you'll need to take for your car. If you will need any of the customisation options below, you will want to have these measurements ready before you place your order.

Customisation Options

Boot Length

You can customise the length of your Boot Buddy or Load Liner to fit your needs. If, for example, your side length differs to your center length, we can curve the front of the Boot Buddy to fit.

Here are the measurements we'll need:

• Side Length

  Measure the left and right sides of your boot from the base of your seats to the front end of your boot.

• Center Length

  Measure the center length of your boot from the base of your seats to the front end of your boot.

Boot Width

You can customise the width of your Boot Buddy or Load Liner to fit your needs.

Here are the measurements we'll need:

• Primary Width

  If your boot has wheel arches, measure the width between the wheel arches.

• Maximum Width

  Measure the full width between the sides of your boot.

Wheel Arches

Boot Buddy is typically designed to fit between the wheel arches of your boot. If your vehicle has wheel arches, this can give you the added benefit of extra storage on either side of the Boot Buddy. If you prefer, you can customise your Boot Buddy or Load Liner to fit over the wheel arches.

In addition to the width measurements above, here are the measurements we'll need:

• Wheel Arch Length

  Measure from the base of your seats to the point your arches begin to curve.

Boot Height

You can customise the height of the back and sides of your Boot Buddy or Load Liner to fit your needs.

Here are the measurements we'll need:

• Back Height

  Measure the height of your back seat from the bottom, along the angle of your seats (if applicable) to the point you want your Boot Buddy to stop. We can make your Boot Buddy adjustable to match the angle of your rake.

• Side Height

  Measure the height of the side of your boot to the point you want your Boot Buddy to stop.

Boot Buddy/Load Liner for Dog Owners

We can customise your Boot Buddy or Load Liner with a series of small punched holes along the high back seat panel, so with the supplied lacing you can secure it to your dog guard or rear seat headrests.

Bumper Protector

Our Bumper Protector is made to fit the width of the opening of your boot. You can customise the Bumper Protector if you need a more narrow width.

Here are the measurements we'll need:

• Bumper Protector Width

  Measure across your boot opening for your preferred width.